date revision title 55PC2221 jacket - radiation-crosslinked, modified etfe conductor size (awg) upper spec limit target value diameter ( in.) weight ( lbs/1000 ft.) target wall target value lower spec limit upper spec limit .0075.0075 .0080 .0080 .0080 .0085 .0090 .0095 .096.108 .126 .144 .159 .190 .228 .276 .0015.0015 .0015 .0015 .0015 .0015 .0015 .0015 55PC2221-24-*55PC2221-22-* 55PC2221-20-* 55PC2221-18-* 55PC2221-16-* 55PC2221-14-* 55PC2221-12-* 55PC2221-10-* 2422 20 18 16 14 12 10 .0060.0060 .0060 .0060 .0060 .0065 .0070 .0075 .105.118 .136 .155 .170 .201 .241 .291 .101.113 .131 .150 .165 .196 .235 .284 specifica tion control dra wing two conductor cable, flat braid shielded, jacketed, general purpose, 600 volt part number 1 / shield coverage: 85% (minimum)voltage withstand test (post environmental): 1000 volts (rms), 60 hz, 1 minute part number: the "*" in the part numbers above shall be replacedby a color code designator with a slash separating the component wire colors and a dash separating the component wire colors from the jacket color. 1 / example: awg 22, red and blue component wires; white jacket: 55PC2221-22-2/6-9 temperature rating: 150c maximum continous conductor temperature voltage rating: 600 volts (rms) at sea level dielectric withstand: 1500 volts (rms), 60 hz crosslink verification: 300 3c for 1 hour jacket color: white preferred jacket elongation and tensile strength: elongation, 50% (minimum) tensil strength, 5000 lbf/in2 (minimum) jacket flaws: spark test, 1000 volts (rms) impulse dielectric test, 6.0 kv (peak) cable ratings and additional requirements shield strand thickness ( .0004) lower spec limit this specification sheet forms a part of the latest issue of raychem specification 55pc. shield - tin-coated copper component wires - 55pc0211 c jacket thickness (in.) construction details 7.49 9.84 13.6318.85 23.08 33.59 49.25 74.61 8.01 10.4814.30 19.72 24.07 34.76 50.80 76.79 4-19-06 tyco electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to buyer. r wire & cable 501 oakside avenueredwood city, ca 94063-3800 phone: 1-800-227-8816 fax: 1-650-361-6297 page 1 of 1 this specification sheet takes precedence over documents referenced herein. referenced documents shall be of the issue in effect on date of invitation for bid. dimensions are in inches and, unless otherwise designated, are nominal 1 / colors and color code designators shall be in accordance with mil-std-681. however, due to length limitations of the raychem part number, an alternative color code may replace mil-std-681 color code designators. (example: 901/902... may be replaced by axxx.) other codes and suffixes may be added to the part number, as necessary, to capture any additional requirements imposed by the purchase order. users should evaluate the suitability of this product for their application. specifications are subject to change without notice. ? 2006 tyco electronics corporation. all rights reserved.
|
