north america (usa): 1-888-41-astec europe (uk): 44 (1384) 842-211 asia (hk): 852-2437-9662 2 special features electrical specs special features 6amps ? point-of-load alliance product ? open frame th or smt termination ? auto-track? sequencing ? output voltage adjust (resistor programming) ? under voltage lockout ? pre-biased start-up 2 ? output on/off inhibit ? -40c to +85c ambient air operation ? non isolated module input input range 3.0 - 3.6v 4.5 - 5.5v 10.8 - 13.2v under voltage lockout with hysterisis efficiency up to 95% output overall regulation 1% of vo typ noise/ripple 30mv typ (2.5vo and below) 1% vo typ (vo > 2.5v) remote sense up to 300mv max transient response 100mv typical for 3.3vo for 50% to 100% i o,max step change 70us recovery time (co = 330uf) over current protection 160% i o,max typical (autorecovery) control inhibit on/off positive enable logic output voltage adjust see output range on page 2 output margin 5% v o,nom output auto-track? (see note 5) specifications subject to change without notice ambient air operating temperature range: -40c to +85c storage temperature: -40c to +125c calculated mtbf: > tba ul,cul 60950 recognition (pending) en 60950 through tuv or vde (pending) environmental total power: 33w input voltages: 3.3v, 5v, 12v no. of outputs: single safety ath06 preliminary
europe astec house, waterfront business park merry hill, dudley west midlands, dy5 1lx, uk telephone: 44 (1384) 842-211 facsimile: 44 (1384) 843-355 americas 5810 van allen way carlsbad, ca 92008 telephone: 760-930-4600 facsimile: 760-930-0698 3 ordering information www.astecpower.com asia units 2111-2116, level 21 tower1, metroplaza 223, hing fong road fwai fong, new territories hong kong telephone: 852-2437-9662 facsimile: 852-2402-4426 input output output 3 efficiency 4 model number voltage voltage current 3.0v to 3.6v 0.8v to 2.5v 6a 95% ATH06T033-9(s)(j) 4.5v to 5.5v 0.8v to 3.6v 6a 95% ath06t05-9(s)(j) 10.8v to 13.2v 1.2v to 5.5v 6a 95% ath06k12-9(s)(j) options: ?-9j? - output trim, th termination, tray packaging ?-9sj? - output trim, smt termination, tray packaging ?-9s? - output trim, smt ternination, t&r packaging pin assignments single output pins gnd : 1 track : 2 vin : 3 inhibit : 4 vo adjust : 5 vout : 6 notes: 1. nominal values apply with sense pins connected to +vout and ground return with other control pins unconnected. 2. pre-bias startup capability exists for 3.3vin and 5vin devices. 3. output derating applies at elevated ambient temperature. 4. typical efficiency taken at (tba) load, 2.5v output (3.3vin device); (tba) load, 3.3v output (5vin device); (tba) load, 5v output (12vin device). 5. consult the technical reference notes when available. 6. mechanical dimensions are nominal values. 7. auto-track ? is a trademark of texas instruments. 8. specification subject to change without notice. * this is a preliminary data sheet. astec reserves the right to make changes to the information contained herein without notice and assumes no liability as a result of its use or application. (rev01: july 31, 2003) through-hole and smt outline [in (mm)]
|
