1 technical data sheet bnc male connector clamp/solder attachment for rg6 confguration connector bnc male connector interface type rg6 cable attachment method (shield/contact) clamp/solder body style straight electrical specifcations impedance, ohms 50 mechanical specifcations size length, in [mm] 1.2 [30.48] width/dia., in [mm] 0.57 [14.48] . weight, lbs [g] 0.041 [18.6] connector type bnc male contact material and plating brass, gold coupling nut material and plating brass, nickel body material and plating brass, nickel dielectric type t efon compliance certifcations (visit www.pasternack.com for current document) rohs compliant y es plotted and other data notes: v alues at 25 c, sea level bnc male connector clamp/solder attachment for rg6 from pasternack enterprises has same day shipment for domestic and international orders. our rf, microwave and fber optic products maintain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: bnc male connector clamp/solder attachment for rg6 PE4377 url: http://www.pasternack.com/bnc-male-standard-rg6-connector-PE4377-p.aspx PE4377 PE4377 rev bnc male connector clamp/solder attachment for rg6
? 2013 pasternack enterprises all rights reserved 2 PE4377 rev scale n/a dwg title cad file 2233 fscm no. 53919 rev. - 051002 size a PE4377 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. 1. slide clamp nut (1), washer (2) & gasket (3) over cable. strip cable as shown. do not nick braid while cutting jacket. taper end of braid to permit assembly of braid clamp (4). slide braid clamp (4) over braid & seat against cable. 2. form braid over clamp nut (4). trim braid back to shoulder. cut dielectric & center conductor to dimension shown. do not nick center conductor. solder contact to center conductor. remove excess solder. do not over heat dielectric. insert cable assembly into body & tighten. assembly procedures bnc male connector clamp/solder attachment for rg6 PE4377 cad drawing
|
