slot-type photomicrosensor with cable ee-spx-w photomicrosensor with built-in amplifier and attached cable reduces external light interference. light modulation effectively reduces external light interference. wide operation volt age range: 5 to 24 vdc easy operation monit oring with bright light indicator. be sure to read safety precautions on page 3. ordering information * these models (ee-spx305/405-w2a only) are not conformed to ce standards. appearance sensing method sensing distance (slot width) output type output configuration cable length model through-beam type npn output dark-on 1 m EE-SPX302-W2A light-on ee-spx402-w2a dark-on ee-spx304-w2a light-on ee-spx404-w2a dark-on ee-spx306-w2a light-on ee-spx406-w2a dark-on ee-spx305-w2a * light-on ee-spx405-w2a * infrared li g ht 3.6 mm 3.6 mm 3.6 mm 5 mm 1
ee-spx-w ratings and specifications i/o circuit diagrams npn output item models EE-SPX302-W2A, ee-spx402-w2a ee-spx304-w2a, ee-spx404-w2a ee-spx306-w2a, ee-spx406-w2a ee-spx305-w2a ee-spx405-w2a sensing distance 3.6 mm (slot width) 5 mm (slot width) *1. the indicator is a gap red led (peak wavelength: 700 nm). *2. the response frequency was measured by detecting the following rotating disk. sensing object opaque: 1 u 0.5 mm min. opaque: 2 u 0.8 mm min. differential distance 0.05 mm max. light source gaas infrared led (pulse lighting) with a peak wavelength of 940 nm indicator * 1 light indicator (red) supply voltage 5 to 24 vdc 10%, ripple (p-p): 5% max. current consumption average: 15 ma max.; peak: 50 ma max. control output npn voltage output: load power supply voltage: 5 to 24 vdc load current: 80 ma max. 80 ma load current with a residual voltage of 1.0 v max. 10 ma load current with a residual voltage of 0.4 v max. response frequency * 2 500 hz min. ambient illumination 3,000 lx max. with incandescent light or sunlight on the surface of the receiver ambient temperature range operating: 10 to +55 q c storage: 25 to +65 q c ambient humidity range operating: 5% to 85% storage: 5% to 95% vibration resistance destruction: 10 to 55 hz, 1.5-mm double amplitude for 2 h each in x, y, and z directions shock resistance destruction: 500 m/s 2 for 3 times each in x, y, and z directions enclosure rating iec ip50 connecting method pre-wired (standard cable length: 1 m) weight 18.5 g material case polycarbonate holder 2 mm 2 mm 2 mm disk disk disk ee-spx305-w2a EE-SPX302-W2A ee-spx306-w2a model output configuration timing charts output circuit ee-spx402-w2a ee-spx404-w2a ee-spx405-w2a ee-spx406-w2a light-on EE-SPX302-W2A ee-spx304-w2a ee-spx305-w2a ee-spx306-w2a dark-on incident interrupted on off on off operates releases h l light indicator (red) output transistor load 1 (relay) load 2 5 to 24 vd c light indicator (red) 1.5 to 3 ma load 1 load 2 main circuit black blue brown ? * volta g e out p ut ( when the sensor is connected to a transistor circuit ) incident interrupted on off on off operates releases h l light indicator (red) output transistor load 1 (relay) load 2 2
ee-spx-w dimensions (unit: mm) ? optical axis (0.5-mm wide) optical axis (1-mm wide) see note. 2.5 2.5 13 3.6 c0.5 2 dia. 6.6 indicator window r3.2 r3.2 7 dia. 6 7 15.6 3 3.5 dia. hole 6.5 21.2 8 1,000 * vinyl-insulated round cable of 3.5 dia., 3 cores, (0.14 mm 2 with 1.0-dia. insulator); standard length: 1 m note: the lug is used to prevent turning and to indicate the optical axis. when installin g , make a fixed hole of 2.1 to 2.3 mm dia. EE-SPX302-W2A ee-spx402-w2a ? optical axis (0.5-mm wide) optical axis (1-mm wide) see note. 2.5 2.5 13 3.6 c0.5 2 dia. 6.6 indicator window r3.2 r3.2 7 dia. 6 6 7 15.6 3 3.5 dia. hole 6.5 21.2 8 1,000 note: the lug is used to prevent turning and to indicate the optical axis. when installing, make a fixed hole of 2.1 to 2.3 mm dia. * vinyl-insulated round cable of 3.5 dia., 3 cores, (0.14 mm 2 with 1.0-dia. insulator); standard length: 1 m ee- s px304-w2a ee-spx404-w2a 3.6 6.6 two, 3.5 dia. holes optical axis (0.5-mm wide) 7.4 7 1.5 max. indicator window 6 8 21.2 1,000 optical axis (1-mm wide) 15.6 3 13.8 19 25 ? * vinyl-insulated round cable of 3.5 dia., 3 cores, ( 0.14 mm 2 with 1.0-dia. insulator ) ; standard len g th: 1 m indicator window ee- s px306-w2a ee-spx406-w2a ? 14.5 1,000 8 6.95 7.2 12.7 15.5 6.35 optical axis window (2 0.8) 3.6 3.2 9 20 two, 3.2 dia. 14.4 20 27.2 5 four, r2 indicator window * vinyl-insulated round cable of 3.5 dia., 3 cores, (0.14 mm 2 with 1.0-dia. insulator); standard length: 1 m 7 dia. ee- s px305-w2a ee-spx405-w2a 4
|