1 technical data sheet 75 ohm n female connector clamp/solder attachment for rg59, rg62, .480 inch d hole 75 ohm n female connector clamp/solder attachment for rg59, rg62, .480 inch d hole confguration connector n female connector interface type rg59,rg62 cable attachment method (shield/contact) clamp/solder body style straight electrical specifcations impedance, ohms 75 mechanical specifcations size length, in [mm] 1.4 [35.56] width/dia., in [mm] 0.625 [16] . weight, lbs [g] 0.068 [30.84] connector type n female contact material and plating silver body material and plating brass, nickel dielectric type ptfe compliance certifcations (visit www.pasternack.com for current document) rohs compliant y es plotted and other data notes: v alues at 25 c, sea level 75 ohm n female connector clamp/solder attachment for rg59, rg62, .480 inch d hole from pasternack enterprises has same day shipment for domestic and international orders. our rf, microwave and fber optic products maintain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: 75 ohm n female connector clamp/solder attachment for rg59, rg62, .480 inch d hole PE4516 url: http://www.pasternack.com/n-female-standard-rg59-rg62-connector-PE4516-p.aspx PE4516 PE4516 rev
? 2013 pasternack enterprises all rights reserved 2 PE4516 rev dwg title PE4516 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. assembly procedures fscm no. 53919 cad file 052102 scale n/a size a 127 1. slide clamp nut (1), washer (2) & gasket (3) over cable. strip cable as shown. do not nick braid while cutting jacket. taper end of braid to permit assembly of braid clamp (4). slide braid clamp (4) over braid & seat against cable. 2. form braid over clamp nut (4). trim braid back to shoulder. cut dielectric & center conductor to dimension shown. do not nick center conductor. solder contact to center conductor. remove excess solder. do not over heat dielectric. insert cable assembly into body & tighten. note: rg62 uses ptfe insert. insert ptfe before contact. taper end first. 75 ohm n female connector clamp/solder attachment for rg59, rg62, .480 inch d hole PE4516 cad drawing
|