universal ac input harmonic correction ac-dc 19" compa tible eurocard 100 watts mul tiple output switching mode power supplies hpu100 series fea tures: accommodate universal ac sources meet iec1000-3-2 harmonic correction meet universal safety standards 19? compatible eurocard format emi meet en 55022 & fcc class b ce marking compliance 3u x 10hp x 160mm vmebus standard general specifica tion efficiency: typ. 73-76%. switching frequency: fixed frequency 83k hz. circuit topology: fixed frequency forward circuit. transient response: output voltage returns in less than 3ms following a 25% load change. safety standard: iec950/ul1950 class i. power density: 2.0 watt / cubic inch. operating temperature: 0 to +50c full load. derates from +50 to +70c by derating 2%/c. storage temperature: -25 to +85c. temperature coefficient: typ. 0.04% /c. cooling: forced air flow is recommended for ta > +50c full load operation. construction format: 10hp(te) x3ux160mm vmebus standard eurocard format. note: all measurements are at nominal input, full load, and +25 unless otherwise specified. specification input specifica tion input voltage: typ. 90-264vac with pfc. input connector: din 41612 at rear. input frequency: 47-63hz. inrush current: typ. <30.6a @ 230vac. input current: 1.0a @ 115vac, 0.5a @ 230vac. dielectric withstand: meet iec950. emi: meet en 55022 & fcc b. power factor correction: meet harmonic correction iec1000-3-2 .pf typ. 0.97-0.98. power indicator: green led. power ok signal: installed. logic inhibit: installed. hold-up time: 20ms @ 115vac & 230vac. earth leakage: less than 0.40ma @ 230vac. output specifica tion output voltage: see ratings chart. output current: see ratings chart. output connector: din 41612 at rear. line regulation: typ. 0.5%. load regulation: main vo1 typ. 1-2.0%. aux.vo2 typ. 2.0% (mag. amp.) aux.vo3 typ. 3.0% (pr). noise & ripple: typ. 1% peak to peak. ovp: built-in at main vo1. adjustability: available at vo1 & vo2. overload protection (olp): fully protected against output overload and short circuit. consult the factory for olp setting.
output voltage/current ratings chart triple output main vo1 ? @ ? aux. vo2 @
|
