spec no: dsae7184 rev no: v.3 date: mar/23/2005 page: 1 of 3 approved: j. lu checked: allen liu drawn: q.m.jiang package dimension s description the yellow source color devices are made with gallium arsenide phosphide on gallium phosphide yellow light emitting diode . l- 710a8rs/1yd yellow t- 1 (3mm) right angle led indicator notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0 .25(0.01") unless otherwise noted. 3. lead spacing is measured where the leads emerge from the package. 4. specifications are subject to change without notice. features pre - trimmed leads for pc mounting. i.c. compatible. pillars are designed for positioning the housing on p.c. board. black case enhances contrast ratio. wide viewing angle. high reliability life measured in years. ul rating : 94v - 0. housing material: type 66 nylon. rohs compliant.
spec no: dsae7184 rev no: v.3 date: mar/23/2005 page: 2 of 3 approved: j. lu checked: allen liu drawn: q.m.jiang selection guid e note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. electrical / optical characteristics at t a =25 c absolute maximum ratings at t a =25 c notes: 1. 1/10 duty cycle, 0.1ms pulse width. 2. 2mm below package base. 3 . 5mm below package base. part no. dice lens type iv (mcd) @ 10ma viewing angle min. typ. 2 ? 1/2 l- 710a8rs/1yd yellow (gaasp/gap) yellow diffused 5 12 40 symbol parameter device typ. max. test conditions units peak peak wavelength yellow 590 nm i f =20ma d dominant wavelength yellow 588 nm i f =20ma ? 1/2 spectral line half - width yellow 35 nm i f =20ma c capacitance yellow 20 pf v f =0v;f=1mhz v f forward voltage yellow 2.1 2.5 v i f =20ma i r reverse current yellow 10 ua v r = 5v parameter yellow units power dissipation 105 mw dc forward current 30 ma peak forward current [1] 140 ma reverse voltage 5 v operating/storage temperature - 40c to +85c lead solder temperature [2] 260c for 3 seconds lead solder temperature [3] 260c for 5 seconds
spec no: dsae7184 rev no: v.3 date: mar/23/2005 page: 3 of 3 approved: j. lu checked: allen liu drawn: q.m.jiang yellow l- 710a8rs/1yd remarks: if special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity: +/ - 15% 3. forward voltage: +/ - 0.1v note: accuracy may depend on the sorting parameters.
|
