spec no: dsad1296 rev no: v.3 date: apr/07/2005 page: 1 of 4 approved: j. lu checked: allen liu drawn: h.q.yuan erp:1202 000388 package dimension s description the hyper red source color devices are made with dh ingaalp on gaas substrate light emitting diode. AM27SURC03 hyper red subminiature solid state lamp features subminiature package. gull wing. long life - solid state reliability. low package profile. package :1000pcs / reel. rohs compliant. notes: 1. all dimensions are in millimeters (inches) . 2. tolerance is 0 .25(0.01") unless otherwise noted . 3. lead spacing is measured where the leads emerge from the package. 4. specifications are subject to change without notice .
spec no: dsad1296 rev no: v.3 date: apr/07/2005 page: 2 of 4 approved: j. lu checked: allen liu drawn: h.q.yuan erp:1202 000388 selection guid e note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. part no. dice lens type iv (mcd) @ 20ma viewing angle min. typ. 2 1/2 AM27SURC03 20 hyper red (ingaalp) water clear 280 1000 electrical / optical characteristics at t a =25 c absolute maximum ratings at t a =25 c note: 1. 1/10 duty cycle, 0.1ms pulse width. symbol parameter device typ. max. test conditions units peak peak wavelength hyper red 640 nm i f =20ma d dominant wavelength hyper red 628 nm i f =20ma ? 1/2 spectral line half - width hyper red 27 nm i f =20ma c capacitance hyper red 45 pf v f =0v;f=1mhz v f forward voltage hyper red 1.9 2.5 v i f =20ma i r reverse current hyper red 10 ua v r = 5v parameter hyper red units power dissipation 170 mw dc forward current 30 ma peak forward current [1] 185 ma reverse voltage 5 v operating / storage temperature - 40c to +85c
spec no: dsad1296 rev no: v.3 date: apr/07/2005 page: 3 of 4 approved: j. lu checked: allen liu drawn: h.q.yuan erp:1202 000388 hyper red AM27SURC03
spec no: dsad1296 rev no: v.3 date: apr/07/2005 page: 4 of 4 approved: j. lu checked: allen liu drawn: h.q.yuan erp:1202 000388 AM27SURC03 tape specifications (units : mm ) recommended soldering pattern (units : mm ) remarks: if special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. wavelength: +/ - 1nm 2. luminous intensity: +/ - 15% 3. forward voltage: +/ - 0.1v note: accuracy may depend on the sorting parameters.
|
