phlatlight ? led development kit product brief dk-136m series and dk-125m series product brief www.luminus.com ? 2008 luminus devices, in c. - all rights reserved pdb-001290 rev 01 overview the dk-136m and dk-125m de- velopment kits for phlatlight products are comprehensive solutions designed specifically to allow for evaluation of prod- ucts in minutes. the kits are a complete solution including high-current drivers optimized for each device and an effi- cient thermal management in- frastructure to ensure the devices can be operated at their optimum point, whether it is for maximum brightness, maximum efficiency or somewhere in- between. this plug and play solution can easily be connected to standard laboratory equipment through standard connectors and allows system designers to save weeks in their development cycles. key features ? compatibility with all cbt and pt series phlatlight products ? dk-136m series kits are optimized for cbt-120 and pt-120 de- vices. dk-125m series kits are optimized for cbt-90 and pt-85 devices. ? driver board supply currents of 36a with dk-136m series kits and 25a with dk-125m series kits. ? available in a single channel or three channel versions main features ? can be operated either in pulsed or continuous waveform (cw) modes ? static current control via on board dial knob ? pulse width modulation input supports pulsed mode opera- tion with duty cycles ranging from 20% to 75% ? optional dynamic current control by user-supplied external device. interface allows drive currents ranging from 0 to max if, controlled by 0-5v input voltage ? frequencies up to 3khz in pulsed mode ? device and circuit parameters reading through test points, including: ? forward voltage, v f . ? forward current, i f . ? device temperature monitoring through thermistor. ? typical thermal resistance of 0.3oc/w from heat sink to ambient ? driver circuitry based off of maxim max16818 ic
phlatlight development kit www.luminus.com ? 2008 luminus devices, inc. - all rights reserved page 2 development kit contents ? 1 or 3 driver cards optimize d for the device evaluated ? 1 or 3 air-cooled heat sinks. ? electrical wiring between driver and phlatlight devices ? thermal interface materials and mounting hardware ? user manual including step-by-step instructions for set-up and operation of the kit. user equipment required ? standard 12v laboratory power supply. ? standard instrumentation - volt meter, oscilloscope. ? pulse generator for pwm dimming in cw mode. ? optional dynamic current management solution note: phlatlight led products are not included in the develop- ment kits and must be purchased separately. product compatibility ordering information the products, their specifications and other information appearing in this document ar e subject to change by luminus devices wi thout notice. luminus devices assumes no liability for errors that may appear in this document, and no liability othe rwise arising from the applicati on or use of the product or information contained herein. none of the information provided herein sh ould be considered to be a representation of the fit ness or suitability of the product for any particular application or as any other form of warranty. luminus devices? product warranties are limited to only such warranties as accompany a purchase contract or purchase order for such products. nothing herein is to be construed as constituting an additio nal warranty. no infor- mation contained in this publication may be considered as a waiv er by luminus devices of any intellectual property rights that luminus devices may have in such information. phlatlight ? is a registered trademark of luminus devices, inc., all rights reserved. luminus devices 1100 technology park drive 978-528-8000 (t) billerica, ma 01821 978-528-8001 (f) e-mail: sales@luminus.com www.luminus.com development kit part number compatible phlatlight leds dk-125m-1, dk-125m-3 cbt-90 * , cst-90 * , cbt-120 ? , pt-85 * , pt-120 ? note *: recommended product for optimal use note ?: product can be used, but no t operated at optimal conditions DK-136M-1, dk-136m-3 cbt-90 ? , cbt-120 * , pt-120 * ordering part number product description dk-125m-1 dk-125m phlatlight development kit, single channel single channel develo pment kit, with 25a driver board, heat sink, cable assemblies and user manual dk-125m-3 dk-125m phlatlight development kit, three channels three channel development kit, with 25a driver board, heat sink, cable assemblies and user manual DK-136M-1 dk-136m phlatlight development kit, single channel single channel develo pment kit, with 36a driver board, heat sink, cable assemblies and user manual dk-136m-3 dk-136m phlatlight development kit, three channels three channel development kit, with 36a driver board, heat sink, cable assemblies and user manual
|
