 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Internationally Approved Rockers Series JWS Distinctive Characteristics Rocker caps and housing available in a variety of colors. Protective barrier available to prevent accidental actuation. Constructed for dust resistance with interior cover of polyamide between actuator and contact area. Easy, crisp actuation. Small size well suited for telecommunication, measuring, automation, and consumer applications. Terminals are molded in to lock out flux, dust, and other contaminants. Outer case of heat resistant resin meets UL94V-0 flammability standard. Spot illuminated rocker available. Actual Size NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 02-08 Internationally Approved Rockers Series JWS General Specifications Electrical Capacity (Resistive Load) Power Level: 10A @ 125/250V AC Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: 10 milliohms maximum 500 megohms minimum @ 500V DC 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum 30,000 operations minimum 10,000 operations minimum Single Pole 3.92N & Double Pole 5.39N 30 Materials & Finishes Rocker: Housing/Case: Movable Contactor: Movable Contacts: Stationary Contacts: End Terminals: Common Terminals: Lamp Terminals: Polyphenylene ether (UL94V-0) Polyamide (UL94V-0) Copper with silver plating Silver Silver Brass with silver plating Copper with silver plating Phosphor bronze with tin plating (illuminated models only) Environmental Data Operating Temp Range: Humidity: Vibration: Shock: Sealing: -25C through +70C (-13F through +158F) for nonilluminated models; -25C through +50C (-13F through +122F) for illuminated models 90 ~ 95% humidity for 96 hours @ 40C (104F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 15 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Dust resistant inner seal Installation Soldering: Cleaning: Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand cleaning locally using alcohol based solution. Standards & Certifications Flammability Standards: UL Recognized: C-UL Recognized: CSA Certified: V DE R VDE Approved: UL94V-0 for rocker & housing/case All JWS models recognized at 6A @ 125/250V AC; UL File No. WOYR2.E44145 All JWS models recognized at 6A @ 125/250V AC; UL File No. WOYR8.E44145 All JWS models certified at 6A @ 125/250V AC; CSA File No. 023535-0-000 All JWS models approved at 5A (3A) @ 125/250V AC; VDE License No. 119153 NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 02-08 Internationally Approved Rockers TYPICAL SWITCH ORDERING EXAMPLE Series JWS JW S RATING 2 1 R A A SPOT ILLUMINATION No Code C D F Nonilluminated Red LED Amber LED Green LED BARRIER TYPES R B No Barrier With Barrier S 10A @ 125/250V AC POLES 1 2 SPST Nonilluminated & Illuminated DPST Nonilluminated only A *B C CAP COLORS Black Ivory Red BARRIER COLOR A Black * For Nonilluminated only CIRCUIT 1 ON NONE OFF HOUSING COLORS A *B Black Ivory IMPORTANT: Standard markings: UL, C-UL, & CSA on 6A models; VDE on 5A models. Specific models & ratings for international approvals noted on General Specifications page. * For Nonilluminated only DESCRIPTION FOR TYPICAL ORDERING EXAMPLE JWS21RAA Black Rocker Cap Black Housing/No Barrier DPST ON-NONE-OFF Circuit Rated 6A @ 125/250V AC NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 02-08 Internationally Approved Rockers RATING S Power Level 6A @ 125/250V AC Series JWS POLES & CIRCUITS Rocker Position Down Pole SP Model JWS11 ON NONE OFF 2-3 OPEN OPEN Center Up Connected Terminals Down Center Up Throw & Schematics Note: Terminal numbers are actually on the switch. SPST INTERNAL CONNECTION 2 3 DP JWS21 ON NONE OFF 1-3 4-6 OPEN OPEN DPST 1 3 4 6 INTERNAL CONNECTION BARRIER TYPES & COLORS R No Barrier B With Barrier No-barrier type has a flat flange which is an integral part of the switch. Barrier Material: Polyamide Finish: Matte Barrier AT219 is factory assembled. Dimensions for barrier are shown in the Accessories section. Barrier Color Available: A Black CAP COLORS Cap Material: Polyphenelene Oxide Finish: Matte Rocker cap is an integral part of the switch and not available separately. * Ivory for nonilluminated models only. Cap Colors Available: A Black B * Ivory C Red HOUSING Material: Polyamide Finish: Matte Colors Available: A Black B Ivory (for nonilluminated models only) TERMINALS (1.2) R .047 (0.65) R .026 (4.75) .187 (6.4) (4.4) .252 .173 (3.25) .128 Thk = (0.5) .020 Solder Lug/.187" (4.75mm) Quick Connect Switch assembly with connectors is not UL, CSA, C-UL, or VDE approved. (5.0) .197 (3.0) (1.8) .118 .071 (1.0) .039 Thk = (0.25) .010 Switch Lamp (spot illuminated models only) 02-08 NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com Internationally Approved Rockers Series JWS D Amber 20mA 15mA 1.9V 5V 0.27mA/C -25C ~ +50C LED COLORS & SPECIFICATIONS FOR SPOT ILLUMINATED MODELS LEDs are supplied as an integral part of illuminated devices and are not available separately. LED polarity markings are on the bottom of the switch. The electrical specifications shown here are determined at a basic temperature of 25C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula in the Supplement section. (+) (-) C Color Red 25mA 20mA 2.0V 4V 0.42mA/C I FM IF VF VRM I F F Green 20mA 15mA 1.95V 5V 0.27mA/C Forward Peak Current Continuous Forward Current Forward Voltage Reverse Peak Voltage Current Reduction Rate Above 25C Ambient Temperature Range PANEL CUTOUT & PANEL THICKNESS RANGES Panel Thickness Ranges: (19.2) .756 Without Barrier: .030" ~ .079" (0.75mm ~ 2.0mm) With Barrier: .024" ~ .059" (0.6mm ~ 1.5mm) (12.9) .508 TYPICAL SWITCH DIMENSIONS Nonilluminated * No Barrier Part No. Single Pole (5.3) .209 (0.5) Typ .020 (6.5) .256 (19.0) .748 (4.75) .187 3 2 (21.0) .827 (15.0) .591 30 (12.3) .484 (10.2) .402 (15.0) .591 (2.0) .079 (16.0) .630 (6.4) .252 (12.4) .488 (12.8) .504 JWS11RCA Nonilluminated * No Barrier Part No. Double Pole (5.3) .209 (1.2)R Typ .047 (0.65)R Typ .026 (5.5) .217 (19.0) .748 (8.5) .335 (0.5) Typ .020 6 4 3 (21.0) .827 (15.0) .591 30 (12.3) .484 (10.2) .402 (15.0) .591 (2.0) .079 (5.6) .220 (6.4) .252 (4.5) (4.75) Typ .177 .187 1 (16.0) .630 (12.4) .488 (12.8) .504 JWS21RAA DPST models have IEC symbols for On-Off on the flange. 02-08 NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com Internationally Approved Rockers TYPICAL SWITCH DIMENSIONS Nonilluminated * With Barrier Part No. Series JWS (4.75) .187 Single Pole (0.5) Typ .020 (6.5) .256 (19.0) .748 3 2 (15.0) .591 (19.5) .768 (21.0) .827 (24.0) .945 JWS11BBA-A (10.2) .402 (15.0) .591 (16.5) .650 (7.0) .276 (13.5) .531 (6.4) .252 (12.4) .488 (12.8) .504 (20.5) .807 Nonilluminated * With Barrier Part No. Double Pole (1.2)R Typ .047 (0.65)R Typ .026 (5.5) .217 (19.0) .748 (8.5) .335 (0.5) Typ .020 6 4 (15.0) .591 3 1 (19.5) .768 (4.5) (4.75) Typ .177 .187 (24.0) .945 (21.0) .827 (10.2) .402 (15.0) .591 (16.5) .650 (7.0) .276 (13.5) .531 (5.6) .220 (6.4) .252 (12.4) .488 (12.8) .504 (20.5) .807 JWS21BAA-A DPST models have IEC symbols for On-Off on the flange. Spot Illuminated * No Barrier Part No. Single Pole (5.3) .209 (6.4) .252 (0.5) Typ .020 (12.4) .488 (4.75) .187 (15.0) .591 30 (12.3) .484 (6.0) .236 (10.2) .402 (15.0) .591 (6.5) Typ .256 (19.0) .748 (1.5) .059 (0.25) 0.01 (1.8) Typ .071 3 2 (21.0) .827 (2.1) .083 (2.0) .079 (16.0) .630 (5.0) .197 (9.2) .362 (12.0) .472 (12.8) .504 (4.0) .157 JWS11RCAF Spot Illuminated * With Barrier (10.2) .402 Part No. Single Pole (6.4) .252 (0.5) Typ .020 (12.4) .488 (4.75) .187 (15.0) .591 (19.5) .768 (6.5) Typ .256 (19.0) .748 (1.5) .059 (0.25) 0.01 (1.8) Typ .071 3 2 (21.0) .827 (24.0) .945 (2.1) .083 (6.0) .236 (15.0) .591 (16.5) .650 (7.0) .276 (13.5) .531 (5.0) .197 (9.2) .362 (12.8) .504 (20.5) .807 (4.0) .157 JWS11BAAF-A NKK Switches * email: sales@nkkswitches.com * Phone (480) 991-0942 * Fax (480) 998-1435 * www.nkkswitches.com 02-08 |
Price & Availability of JWS11BBA-A
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |