 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage Control Voltage OPERATING SPECIFICATIONS PARAMETER Center Frequency Frequency Calibration, Vc=2.18 Vdc Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Phase Jitter (BW=12KHz to 20MHz) Phase Jitter (BW=10Hz to 20MHz) Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. INTPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% PACKAGE CHARACTERISTICS Package (Voh) (Vol) (Ioh) (Ioh) MINIMUM 4.5 -4 45 NOMINAL 50 MAXIMUM 15 0.4 4 55 6 UNITS pf Vdc Vdc mA mA % nS (Vc) MINIMUM 0.5 -30 18 5 100k NOMINAL 2.18 MAXIMUM 4.1 -18 30 UNITS Vdc ppm ppm ppm/V Ohm TABLE 4.0 NOTE 6 6 (Vcc) (Icc) (Fo) MINIMUM 1.544 -1.5 -0.25 -30 -2.5 -4.6 0 4.75 5.0 -90 -135 NOMINAL MAXIMUM 20.0 1.5 0.25 30 2.5 4.6 70 5.25 350 1 3 3 10 5 1 2 UNITS MHz ppm ppm ppb ppm ppm C Vdc mA ps rms ps rms ps rms dBc/Hz dBc/Hz mS Minutes nS nS 1 2 3 4 UNITS (Vcc) (Vc) MINIMUM -40 -0.5 -0.5 NOMINAL MAXIMUM 85 7.0 7.0 UNITS C Vdc Vdc TABLE 2.0 NOTE TABLE 1.0 NOTE ASOV5S3 DESCRIPTION 5 The Connor-Winfield ASOV5S3 is a true Surface Mount 5.0V Oven Controlled Crystal Oscillator (OCXO) with an HCMOS output. The ASOV5S3 is designed for Stratum 3 applications requiring tight frequency stability and low jitter. TABLE 3.0 NOTE FEATURES FREQUENCY ADJUST 5.0V OPERATION LOW JITTER <1pS RMS TEMPERATURE STABILITY 0.25ppm FREQUENCY TOLERANCE OF 4.6ppm OVER TWENTY YEARS SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Surface Mount, Non-hermetic package consisting of an FR4 substrate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a mel ting point of 221C. The peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds Ultrasonic cleaning is not recommended PROCESS RECOMMENDATIONS Solder Reflow Wash Notes: ORDERING INFORMATION 1) 2) 3) 4) Initial calibration @ 25C, Vc=2.18 Vdc. Frequency vs. temperature stability At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging, Vc=2.18 Vdc. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25C 6) Referenced to Fo @ 25C, Positive Transfer Characteristic ASOV5S3 - 12.80MHz OCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx016 PAGE 1 OF 2 REV: 04 DATE: 6/24/03 aCopyright 2001 Connor-Winfield all rights reserved. CW 0107 ASOV5S3 12.80M SURFACE MOUNT 5.0V HCMOS STRATUM 3 OCXO THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55C to 125C, 20 cycles,10 minute dwell, 1m inute transition. SOLDERING Pad Solderability: Per MIL-STD-883, Method 200. 8 hour steam age prior to 254C 5C Solder pot dip, 95% Coverage. Solder Reflow: The component solder internal to this device has a melt ing point of 221C, the peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G's peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G's, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65C, 10 cycles 10C to 65C. PIN FUNCTION .330 max (8.382mm) CW DATE CODE ASOV5S3 12.80M 1 7 8 14 CONTROL VOLTAGE GROUND (CASE) OUTPUT Vcc Dimensional Tolerance: .005 (.127mm) KEEP OUT AREA 90% .830 (21.08mm) 50% 10% .565 (14.35mm) CONTROL VOLTAGE 4.1Vdc POWER SUPPLY 5.0Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx016 PAGE 2 OF 2 REV: 04 DATE: 6/24/03 aCopyright 2001 Connor-Winfield all rights reserved. |
Price & Availability of ASOV5S3
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |