|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
Power PARAGONTM DIGITAL Four Channel DSP System with FRONTWAVE (R) GB3211/GB3221 PRELIMINARY DATA SHEET FEATURES * high power applications * highly configurable, versatile DSP platform * high fidelity multi-channel AGC signal processing * 95dB input dynamic range with HRXTM Headroom Extension * fully programmable via serial data interface * high performance data converters - dual, oversampled A/Ds; over-sampled D/A with efficient switched-mode output power amp * SOUNDDESIGNTM high-fidelity audio quality * drives zero-bias 2-terminal receivers * multiple communication rates up to 85.3kb/s * multi-memory * internal/external volume control * volume control taper determined by external VC * 2 memory select pads * tri-state memory select operation * audible memory change indicator thinSTAXTM PACKAGING Hybrid typical dimensions: 0.227 x 0.125 x 0.060 in (5.76 x 3.18 x 1.52 mm) VB 12 205n VREG 7 REGULATOR DESCRIPTION GB3211 / GB3221 The GB3211 (GB3221) hybrid is a programmable DSP system based on a multi-channel compression circuit. This hybrid is designed for low impedance receivers. It can be used as a platform for a wide range of hearing aid applications. It also offers a seperate supply line to the A/D and H-Bridge circuits. The reflowable thinSTAXTM packaging enables easy integration into BTE applications. This versatile DSP hybrid is capable of multiple configurations and has a wide range of functions. The GB3211 hybrid contains the GC5051 controller chip and the GB3221 hybrid contains the GC5057 controller chip. The only difference between the GC5051 and the GC5057 is in their Power On Reset (POR) behaviour. For a detailed description of the POR behaviour of the GC5051 and GC5057 controller chips, please refer to PARAGONTM DIGITAL Reference Guide, Document #20143. The GB3211 and the GB3221 hybrid code programmed into the GC5051 and the GC5057 controller chips is "7". This data sheet is a part of a set of documents available for this product. Please refer to Getting Started with PARAGONTM DIGITAL" information note for a list of other documents. VC 5 VC A/D SDA 4 MS 11 MS2 13 VBP 14 GB3211 (GB3221) 13n INTERFACE EEPROM FMIC 9 70n A/D CHANNEL 1 FRONTWAVE CHANNEL 2 S D/A HBRIDGE 15 OUT+ 1 OUT- 70n RMIC T 6 A/D CHANNEL 3 10 60n CHANNEL 4 MGND 8 3 All resistors in ohms, all capacitors in farads unless otherwise stated. GND 2 PGND BLOCK DIAGRAM Doc.No.20475 - 4 [Rev. December 2003] 1 of 7 ABSOLUTE MAXIMUM RATING Operating Temperature Range: Storage Temperature Range: Absolute Maximum Power Dissipation: Maximum Operating Supply Voltage: Absolute Maximum Supply Voltage: -10C to 40C -20C to 70C 25mW 1.5VDC 2VDC PAD CONNECTION MGND 8 FMIC 9 T 10 MS 11 VB 12 MS2 13 14 VBP GB3211 / GB3221 15 OUT+ 7 VREG 6 RMIC 5 VC 4 SDA 3 GND 2 PGND 1 OUT- CAUTION ELECTROSTATIC SENSITIVE DEVICES DO NOT OPEN PACKAGES OR HANDLE EXCEPT AT A STATIC-FREE WORKSTATION CAUTION LEVEL 3 MOISTURE SENSITIVE DEVICES DO NOT OPEN PACKAGES EXCEPT UNDER CONTROLLED CONDITIONS ELECTRICAL CHARACTERISTICS Conditions: Supply Voltage VB = 1.3V; Temperature = 25C PARAMETER Hybrid Current Minimum Operating Supply Voltage Supply Voltage turn on threshold Supply Voltage Hysteresis Supply Voltage during Communication Hybrid Current during Communication EEPROM Burn Cycles Low Frequency System Bandwidth High Frequency System Bandwidth Total Maximum System Gain SYMBOL AMP VBOFF VBON CONDITIONS See current consumption section Ramp down Ramp up MIN 0.94 1.06 90 TYP 700 1.0 1.10 100 1.35 3.7 140 16 83 MAX 1.05 1.16 110 1.5 - UNITS A V V mV V mA cycles VBC P During Communication Programming (<5 ms) Note 2 1.19 100k 100 15.2 225 16.8 85 Hz kHz dB AV VIN = -95 dBV @ 3kHz; squelch disabled See Note 1. 81 Converter Gain Total Harmonic Distortion THD at Maximum Input Clock Frequency REGULATOR Regulator Voltage Regulator Supply Rejection ACONV THD THDM clk A/D + D/A gain. VIN = -40 dBV VIN = -15 dBV, HRX - ON 27 1.945 29 0.05 1.5 2.048 31 1 3 2.151 dB % % MHz VREG PSRRREG 0.90 - 0.95 50 1.00 - V dB 2 of 7 GENNUM CORPORATION 20475 - 4 ELECTRICAL CHARACTERISTICS PARAMETER INPUT Input Referred Noise Input Impedance Anti-alias Filter Rejection (input referred) Maximum Input Level Input Dynamic Range Audio Sample Rate A/D Dynamic Range OUTPUT Maximum RMS Output Voltage D/A Dynamic Range Output Impedance VOLUME CONTROL Volume Control Resistance Volume Control Range MS INPUT Low State Open State High State MS2 INPUT Pull Down Resistance Logic 1 Voltage Rising Edge Threshold Falling Edge Threshold Hysteresis (CONTINUED) Conditions: Supply Voltage VB = 1.3V; Temperature = 25C SYMBOL CONDITIONS MIN TYP MAX UNITS IRN ZIN Bandwidth 100Hz - 8kHz 11.2 -108 16 80 -106 22 - dBV GB3211 / GB3221 k dB =clk-8kHz, VIN = -40dBV - HRX - ON, Bandwidth 100Hz - 8kHz 30.4 Bandwidth 100Hz - 8kHz - -15 95 32 86 33.6 - dBV dB kHz dB 0dBFS = 1kHz Bandwidth 100Hz - 8kHz ZOUT Note 2 -3 80 - -1 - 1 20 dBV dB RVC A 160 47.5 200 48 240 48.5 k dB Lo Z Hi 0 VREG/3 2VREG/3 - VREG/3 2VREG/3 VB V V V VREG 0.5 0.25 0.1 1 0.69 0.45 0.24 VB 0.9 0.5 0.4 M V V V V 3 of 7 GENNUM CORPORATION 20475 - 4 ELECTRICAL CHARACTERISTICS PARAMETER SDA INPUT Logic 0 Voltage Logic 1 Voltage SDA OUTPUT Standby Pull Up Current Sync Pull Up Current Logic 0 Current (Pull Down) Logic 1 Current (Pull Up) Synchronization Time (Synchronization Pulse Width) (CONTINUED) Conditions: Supply Voltage VB = 1.3V; Temperature = 25C SYMBOL CONDITIONS MIN TYP MAX UNITS Note 2 Note 2 0 1 - 0.3 1.3 V GB3211 / GB3221 V 1.4 450 225 225 TSYNC Baud = 0 Baud = 1 Baud = 2 Baud = 3 Baud = 4 Baud = 5 Baud = 6 Baud = 7 237 118 59 29.76 14.88 7.44 3.72 1.86 2 500 250 250 250 125 62.5 31.25 15.63 7.81 3.91 1.95 2.6 550 275 275 263 132 66 32.81 16.41 8.20 4.10 2.05 A A A A s s s s s s s s NOTE 1: Total System Gain consists of: Wideband System Gain + High and Low Independent Channel Gains + Converter Gain Total System Gain is calibrated during Cal/Config process. NOTE 2: Sample tested. SUPPORT SOFTWARE All support software for the GB3211 / GB3221 is available from Gennum Web site: www.gennum.com/hip/software/index.html. 4 of 7 GENNUM CORPORATION 20475 - 4 VB 200k GB3211 / GB3221 12 205n 7 REGULATOR 5 VC A/D 4 11 13 14 GB3211 (GB3221) 13n INTERFACE EEPROM 9 3k9 70n A/D CHANNEL 1 OUT 15 FRONTWAVE CHANNEL 2 S D/A HBRIDGE LP FILTER 1 70n 6 3k9 10 1k 60n CHANNEL 4 A/D CHANNEL 3 8 3 All resistors in ohms, all capacitors in farads unless otherwise stated. 2 Figure 1: Test Circuit 22 47 MS2 MS VB VC 200k(log) 12 205n 7 REGULATOR 5 VC A/D 4 11 13 14 GB3211 (GB3221) 13n INTERFACE EEPROM 9 70n A/D CHANNEL 1 15 FRONTWAVE CHANNEL 2 S D/A HBRIDGE 70n 6 A/D CHANNEL 3 1 Knowles or Microtronic zero-bias receiver 10 60n CHANNEL 4 8 3 All resistors in ohms, all capacitors in farads unless otherwise stated. Knowles or Microtronic microphones 2 Figure 2: Sample Application Circuit 5 of 7 GENNUM CORPORATION 20475 - 4 T-coil MS switch (N.O.) MS2 switch GB3211 / GB3221 Front Mic + Zero Biased Receiver Rear Mic + VC CS44 Figure 3: Assembly Diagram 6 of 7 GENNUM CORPORATION + 20475 - 4 - PACKAGE DIMENSIONS PAD LOCATIONS 0.227 (5.76) PAD NO. 1 PAD POSITION X 0 -31 -63 -95 -127 -159 -191 -191 -159 -127 -95 -63 -30 2 0 0 -0.787 -1.600 -2.413 -3.226 -4.039 -4.851 -4.851 -4.039 -3.226 -2.413 -1.600 0.762 0.051 0 Y 0 -1.5 -0.25 -0.25 -1.5 2.75 5.5 75.5 78.25 82.5 81.25 81.25 85.5 82.5 39 0 -0.038 -0.006 -0.006 -0.038 0.070 0.140 1.918 1.988 2.0965 2.0638 2.0638 2.172 2.096 0.991 PAD DIMENSION Xdim 20 22 22 22 22 22 22 22 22 22 22 22 26 16 20 0.508 0.559 0.559 0.559 0.559 0.559 0.559 0.559 0.559 0.559 0.559 0.559 0.660 0.406 0.508 Ydim 29 26 28.5 28.5 26 34.5 40 34.5 26 28.5 28.5 24.5 26 29 0.737 0.660 0.724 0.724 0.660 0.876 1.016 1.016 0.876 0.660 0.724 0.724 0.622 0.660 0.737 GB3211 / GB3221 0.125 (3.18) GB3211 2 3 4 5 6 7 8 0.065 MAX (1.65) 9 10 11 12 8 9 10 11 12 13 14 13 14 15 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 15 1 7 6 5 4 3 2 0.022 (0.559) 0.0175 (0.445) Dimension units are in inches. Dimensions in parentheses are in millimetres, converted from inches and include minor rounding errors. 1.0000 inches = 25.400mm Dimension tolerances: 0.003 (0.08) unless otherwise stated. Work order number: XXXXXX This Hybrid is designed for either point-to-point manual soldering or for reflow according to Gennum's reflow process (Information Note 521-45). DOCUMENT IDENTIFICATION PRELIMINARY DATA SHEET The product is in production. Gennum reserves the right to make changes at any time to improve reliability, function or design, in order to provide the best product possible. REVISION NOTES: GB3221 hybrid code changed. For latest product information, visit www.gennum.com GENNUM CORPORATION MAILING ADDRESS: P.O. Box 489, Stn A, Burlington Ontario, Canada L7R 3Y3 Tel. +1 (905) 632-2996 fax: +1 (905) 632-2814 SHIPPING ADDRESS: 970 Fraser Drive, Burlington, Ontario, Canada L7L 5P5 GENNUM JAPAN CORPORATION Shinjuku Green Tower Building 27F, 6-14-1, Nishi Shinjuku, Shinjuku-ku, Tokyo, 160-0023 Japan Tel. +81 (03) 3349-5501, Fax. +81 (03) 3349-5505 Gennum Corporation assumes no responsibility for the use of any circuits described herein and makes no representations that they are free from patent infringement. (c) Copyright October 2001 Gennum Corporation. All rights reserved. Printed in Canada. GENNUM CORPORATION 7 of 7 20475 - 4 mm MIL 40 |
Price & Availability of GB3221 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |