|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) FEATURES * * * * * * * 19MHz to 65MHz fundamental crystal input. Output range: 9.5MHz - 65MHz Complementary outputs: PECL or LVDS output. Selectable OE Logic (enable high or enable low). Integrated variable capacitors. Supports 2.5V or 3.3V Power Supply. Available in 16 pin TSSOP package. PIN CONFIGURATION VDD XIN XOUT DNC S2 OE 1 2 16 15 DNC DNC GNDBUF QBAR VDDBUF Q GNDBUF GND ABV208x 3 4 5 6 7 8 14 13 12 11 10 9 DESCRIPTION The ABV2088 (PECL) and ABV2089 (LVDS) are VCXO ICs specifically designed to work with fundamental crystals between 19MHz and 65MHz. The selectable divide by two feature extends the operation range from 9.5MHz to 65MHz. They require very low current into the crystal resulting in better overall stability. The OE logic feature allows selection of enable high or enable low. VCON GND OUTPUT SELECTION AND ENABLE OE_SELECT OE_CTRL State 0 1 (Default) BLOCK DIAGRAM 0 1 (Default) 0 (Default) 1 Tri-state Output enabled Output enabled Tri-state O Q VCON X+ XOscillator Amplifier with Integrated Varicaps Q Input selection: Bond to GND to set to "0", bond to VDD to set to "1" No connection results to "default" setting through internal pull-up/-down. OE_CTRL: Logical states defined by PECL levels if OE_SELECT is "1" Logical states defined by CMOS levels if OE_SELECT is "0" S2 OUTPUT FREQUENCY DIVIDE BY TWO SELECTOR S2 Output ABV208X Block Diagram 0 1 Intput/2 Input 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 1 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) PIN AND PAD ASSIGNMENT Name VDD XIN XOUT DNC S2 OE_CTRL VCON GND GNDBUF Q VDDBUF QBAR GNDBUF DNC DNC Pin# 1 2 3 4 5 6 8 9 10 11 12 13 14 15 16 Description Power Supply. Crystal input. See Crystal Specification on page 3. Crystal output. See Crystal Specification on page 3. Do Not Connect. Output Divide by Two selector pin. See the OUTPUT DIVIDE BY TWO SELECTOR Table on page 1. Output Enable input. See OUTPUT SELECTION AND ENABLE TABLE on page 1. Voltage control input. Ground. Ground for output buffer circuitry. PECL or LVDS output. Power supply for output buffer circuitry. Complementary PECL or LVDS output. Ground for output buffer circuitry. Do Not Connect. Do Not Connect. ELECTRICAL SPECIFICATIONS 1. Absolute Maximum Ratings PARAMETERS Supply Voltage Input Voltage, dc Output Voltage, dc Storage Temperature Ambient Operating Temperature* Junction Temperature Lead Temperature (soldering, 10s) ESD Protection, Human Body Model SYMBOL VDD VI VO TS TA TJ MIN. -0.5 -0.5 -65 -40 MAX. 4.6 VDD+0.5 VDD+0.5 150 85 125 260 2 UNITS V V V C C C C kV Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied. * Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only. 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 2 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) 2. Crystal Specifications PARAMETERS Crystal Resonator Frequency Crystal Loading Rating Interelectrode Capacitance Recommended ESR SYMBOL FXIN CL (xtal) C0 RE CONDITIONS Fundamental MIN. 19 TYP. 8 MAX. 65 5 30 UNITS MHz pF pF AT cut 3. Voltage Control Crystal Oscillator (3.3V) PARAMETERS VCXO Stabilization Time * VCXO Tuning Range CLK output pullability On-chip Varicaps control range Linearity VCXO Tuning Characteristic VCON input impedance VCON modulation BW SYMBOL TVCXOSTB CONDITIONS From power valid FXIN = 19 - 65MHz; XTAL C0/C1 < 250 0V VCON 3.3V VCON=1.65V, 1.65V VCON = 0 to 3.3V MIN. TYP. MAX. 10 UNITS ms ppm ppm pF % ppm/V k kHz 200* 100* 4 - 18* 10* 65 60 0V VCON 3.3V, -3dB 25 Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits. 4. General Electrical Specifications PARAMETERS Supply Current (Loaded Outputs) Operating Voltage Output Clock Duty Cycle Short Circuit Current SYMBOL IDD VDD CONDITIONS PECL/LVDS @ 1.25V (LVDS) @ VDD - 1.3V (PECL) MIN. TYP. MAX. 100/80 UNITS mA V % mA 2.97 45 45 50 50 50 3.63 55 55 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 3 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) 5. Jitter Specifications PARAMETERS Period jitter RMS at 27MHz Period jitter peak-to-peak at 27MHz Accumulated jitter RMS at 27MHz Accumulated jitter peak-to-peak at 27MHz Random Jitter Measured on Wavecrest SIA 3000 CONDITIONS With capacitive decoupling between VDD and GND. Over 10,000 cycles With capacitive decoupling between VDD and GND. Over 1,000,000 cycles. "RJ" measured on Wavecrest SIA 3000 MIN. TYP. 2.3 18.5 2.3 24 2.3 MAX. 20 UNITS ps 25 ps ps 6. Phase Noise Specifications PARAMETERS Phase Noise relative to carrier FREQUENCY 27MHz @10Hz -75 @100Hz -100 @1kHz -125 @10kHz -140 @100kHz -145 UNITS dBc/Hz Note: Phase Noise measured on Agilent E5500 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 4 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) 7. LVDS Electrical Characteristics PARAMETERS Output Differential Voltage VDD Magnitude Change Output High Voltage Output Low Voltage Offset Voltage Offset Magnitude Change Power-off Leakage Output Short Circuit Current SYMBOL VOD VOD VOH VOL VOS VOS IOXD IOSD CONDITIONS MIN. 247 -50 TYP. 355 MAX. 454 50 UNITS mV mV V V V mV uA mA RL = 100 (see figure) 1.4 0.9 1.125 0 1.1 1.2 3 1 -5.7 1.6 1.375 25 10 -8 Vout = VDD or GND VDD = 0V 8. LVDS Switching Characteristics PARAMETERS Differential Clock Rise Time Differential Clock Fall Time LVDS Levels Test Circuit OUT SYMBOL tr tf CONDITIONS RL = 100 CL = 10 pF (see figure) MIN. 0.2 0.2 TYP. 0.7 0.7 MAX. 1.0 1.0 UNITS ns ns LVDS Switching Test Circuit OUT 50 CL = 10pF VOD VOS VDIFF RL = 100 50 CL = 10pF OUT OUT LVDS Transistion Time Waveform OUT 0V (Differential) OUT 80% VDIFF 20% 0V 80% 20% tR tF 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 5 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) 9. PECL Electrical Characteristics PARAMETERS Output High Voltage Output Low Voltage SYMBOL VOH VOL CONDITIONS RL = 50 to (VDD - 2V) (see figure) MIN. VDD - 1.025 MAX. VDD - 1.620 UNITS V V 11. PECL Switching Characteristics PARAMETERS Clock Rise Time Clock Fall Time SYMBOL tr tf PECL Levels Test Circuit CONDITIONS @20/80% - PECL @80/20% - PECL MIN. TYP. 0.6 0.5 MAX. 1.5 1.5 UNITS ns ns PECL Output Skew VDD OUT OUT 50 2.0V 50% 50 OUT OUT tSKEW PECL Transistion Time Waveform DUTY CYCLE 45 - 55% 55 - 45% OUT 80% 50% 20% OUT tR tF 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 6 Preliminary ABV2088/89 Low Phase Noise VCXO (9.5-65MHz) PACKAGE INFORMATION 16 PIN TSSOP ( mm ) Symbol A A1 B C D E H L e Min. Max. 1.20 0.05 0.15 0.19 0.30 0.09 0.20 4.90 5.10 4.30 4.50 6.40 BSC 0.45 0.75 0.65 BSC E H D A A1 e B C L ORDERING INFORMATION For part ordering, please contact our Sales Department: 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 PART NUMBER The order number for this device is a combination of the following: Device number, Package type and Operating temperature range ABV208x PART NUMBER xC TEMPERATURE C=COMMERCIAL I=INDUSTRIAL PACKAGE TYPE O=TSSOP Order Number ABV2088OC-T ABV2088OC ABV2089OC-T ABV2089OC Marking ABV2088 OC ABV2088 OC ABV2089 OC ABV2089 OC Package Option TSSOP TSSOP TSSOP TSSOP - Tape and Reel - Tube - Tape and Reel - Tube Abracon Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Abracon is believed to be accurate and reliable. However, Abracon makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: Abracon's products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of Abracon Corporation. 30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 7 |
Price & Availability of ABV2089OC-T |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |