 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| 74F132 Quad 2-Input NAND Schmitt Trigger May 2007 74F132 Quad 2-Input NAND Schmitt Trigger General Description The F132 contains four 2-input NAND gates which accept standard TTL input signals and provide standard TTL output levels. They are capable of transforming slowly changing input signals into sharply defined, jitterfree output signals. In addition, they have a greater noise margin than conventional NAND gates. Each circuit contains a 2-input Schmitt Trigger followed by level shifting circuitry and a standard FAST output structure. The Schmitt Trigger uses positive feedback to effectively speed-up slow input transitions, and provide different input threshold voltages for positive and negative-going transitions. This hysteresis between the positive-going and negative-going input threshold (typically 800mV) is determined by resistor ratios and is essentially insensitive to temperature and supply voltage variations. tm Ordering Information Order Number 74F132SC 74F132SJ Package Number M14A M14D Package Description 14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow 14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide Devices also available in Tape and Reel. Specify by appending the suffix letter "X" to the ordering number. Connection Diagram Logic Symbol IEEE/IEC Unit Loading/Fan Out Pin U.L. Input IIH/IIL, Names Description HIGH/LOW Output IOH/IOL An, Bn On Inputs Outputs 1.0 / 1.0 50 / 33.3 20A / -0.6mA -1mA / 20mA Function Table Inputs A L L H H Outputs B L H L H O H H H L H = HIGH Voltage Level FAST(R) is a registered trademark of Fairchild Semiconductor Corporation. (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 L = LOW Voltage Level www.fairchildsemi.com 74F132 Quad 2-Input NAND Schmitt Trigger Absolute Maximum Ratings Stresses exceeding the absolute maximum ratings may damage the device. The device may not function or be operable above the recommended operating conditions and stressing the parts to these levels is not recommended. In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability. The absolute maximum ratings are stress ratings only. Symbol TSTG TA TJ VCC VIN IIN VO Storage Temperature Parameter Ambient Temperature Under Bias Junction Temperature Under Bias VCC Pin Potential to Ground Pin Input Voltage(1) Input Current(1) Voltage Applied to Output in HIGH State (with VCC = 0V) Standard Output 3-STATE Output Current Applied to Output in LOW State (Max.) ESD Last Passing Voltage (Min.) Rating -65C to +150C -55C to +125C -55C to +150C -0.5V to +7.0V -0.5V to +7.0V -30mA to +5.0mA -0.5V to VCC -0.5V to 5.5V twice the rated IOL (mA) 4000V Note: 1. Either voltage limit or current limit is sufficient to protect inputs. Recommended Operating Conditions The Recommended Operating Conditions table defines the conditions for actual device operation. Recommended operating conditions are specified to ensure optimal performance to the datasheet specifications. Fairchild does not recommend exceeding them or designing to absolute maximum ratings. Symbol TA VCC Supply Voltage Parameter Free Air Ambient Temperature Rating 0C to +70C +4.5V to +5.5V (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 www.fairchildsemi.com 2 74F132 Quad 2-Input NAND Schmitt Trigger DC Electrical Characteristics Symbol VT+ VT- VT VCD VOH VOL IIH IBVI ICEX VID IOD IIL IOS ICCH ICCL Parameter Positive-going Threshold Negative-going Threshold Hysteresis (VT - VT + -) VCC 5.0 5.0 5.0 Min. Min. Min. Max. Max. Max. 0.0 0.0 Max Max Max Max Conditions Min. 1.5 0.7 0.4 Typ. Max. 2.0 1.1 -1.2 Units V V V V V Input Clamp Diode Voltage Output HIGH Voltage 10% VCC 5% VCC Output LOW Voltage Input HIGH Current Input HIGH Current Breakdown Test Output HIGH Leakage Current Input Leakage Test Output Leakage Circuit Current Input LOW Current Output Short-Circuit Current Power Supply Current Power Supply Current 10% VCC IIN = -18mA IOH = -1mA IOH = -1mA IOL = 20mA VIN = 2.7V VIN = 7.0V VOUT = VCC IID = 1.9A, All Other Pins Grounded VIOD = 150mV, All Other Pins Grounded VIN = 0.5V VOUT = 0V VO = HIGH VO = LOW -60 4.75 2.5 2.7 0.5 5.0 7.0 50 V A A A V 3.75 -0.6 -150 17.0 18.0 A mA mA mA mA AC Electrical Characteristics TA = +25C, VCC = +5.0V, CL = 50pF Symbol tPLH tPHL TA = 0C to +70C, VCC = +5.0V, CL = 50pF Min. 3.5 5.0 Parameter Propagation Delay, An, Bn to On Min. 4.0 5.0 Typ. Max. 10.5 12.5 Max. 12.0 13.0 Units ns (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 www.fairchildsemi.com 3 74F132 Quad 2-Input NAND Schmitt Trigger Physical Dimensions Dimensions are in millimeters unless otherwise noted. Figure 1. 14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow Package Number M14A (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 www.fairchildsemi.com 4 74F132 Quad 2-Input NAND Schmitt Trigger Physical Dimensions (Continued) Dimensions are in millimeters unless otherwise noted. Figure 2. 14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide Package Number M14D (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 www.fairchildsemi.com 5 74F132 Quad 2-Input NAND Schmitt Trigger TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks. ACEx Across the board. Around the world.TM ActiveArrayTM BottomlessTM Build it NowTM CoolFETTM CROSSVOLTTM CTLTM Current Transfer LogicTM DOMETM 2 E CMOSTM (R) EcoSPARK EnSignaTM FACT Quiet SeriesTM (R) FACT (R) FAST FASTrTM FPSTM (R) FRFET GlobalOptoisolatorTM GTOTM HiSeCTM (R) i-LoTM ImpliedDisconnectTM IntelliMAXTM ISOPLANARTM MICROCOUPLERTM MicroPakTM MICROWIRETM Motion-SPMTM MSXTM MSXProTM OCXTM OCXProTM (R) OPTOLOGIC (R) OPTOPLANAR PACMANTM PDP-SPMTM POPTM (R) Power220 (R) Power247 PowerEdgeTM PowerSaverTM Power-SPMTM (R) PowerTrench Programmable Active DroopTM (R) QFET QSTM QT OptoelectronicsTM Quiet SeriesTM RapidConfigureTM RapidConnectTM ScalarPumpTM SMART STARTTM (R) SPM STEALTHTM SuperFETTM SuperSOTTM -3 SuperSOTTM -6 SuperSOTTM -8 SyncFETTM TCMTM (R) The Power Franchise TM TinyBoostTM TinyBuckTM (R) TinyLogic TINYOPTOTM TinyPowerTM TinyWireTM TruTranslationTM SerDesTM (R) UHC UniFETTM VCXTM WireTM DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. THESE SPECIFICATIONS DO NOT EXPAND THE TERMS OF FAIRCHILD'S WORLDWIDE TERMS AND CONDITIONS, SPECIFICALLY THE WARRANTY THEREIN, WHICH COVERS THESE PRODUCTS. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury of the user. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Advance Information Preliminary Product Status Formative or In Design First Production Definition This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. This datasheet contains preliminary data; supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve design. This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve design. This datasheet contains specifications on a product that has been discontinued by Fairchild Semiconductor. The datasheet is printed for reference information only. Rev. I26 2. A critical component in any component of a life support, device, or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. No Identification Needed Full Production Obsolete Not In Production (c)1988 Fairchild Semiconductor Corporation 74F132 Rev. 1.3 www.fairchildsemi.com 6 |
Price & Availability of 74F13207
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |