 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Data Sheet No. PD 10059 Series PVN013 Microelectronic Power IC HEXFET Power MOSFET Photovoltaic Relay (R) Single Pole, Normally Open, 0-20V, 2.5A AC/ 4.5A DC General Description The PVN013 Series Photovoltaic Relay at 100 milliohms features the lowest possible on-state resistance in a miniature package -- lower than a comparable reed relay. The PVN013 is a single-pole, normally open solid-state relay. It utilizes a GenerationV HEXFET output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED) which is optically isolated from the photovoltaic generator. These units exceed the performance capabilities of electromechanical relays in life, sensitivity, stable onresistance, low off-state leakage, miniaturization, magnetic insensitivity and ruggedness. They are ideally suited for switching high currents or low level signals without distortion or injection of electrical noise. Series PVN013 Relays are packaged in a 6-lead molded DIP package with either through-hole or surface mount (gull-wing) terminals. They are available in standard plastic shipping tubes or on tapeand-reel. Please refer to part identification information opposite. Features 100m On-Resistance GenV HEXFET output Bounce-free operation 2.5 - 4.5 Amp capacity Linear AC/DC operation 4,000 VRMS I/O isolation Solid-State reliability UL recognition pending ESD Tolerance: 4000V Human Body Model 500V Machine Model Applications Portable Electronics Industrial Control Computers and Peripheral Devices Audio Equipment Power Supplies and Power Distribution Instrumentation Part Identification PVN013 PVN013S PVN013S-T through-hole surface-mount surface-mount, tape and reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) Series PVN013 Electrical Specifications (-40C TA +85C unless otherwise specified) INPUT CHARACTERISTICS Minimum Control Current (see figure 1) Maximum Control Current for Off-State Resistance @ TA = +25C Control Current Range (Caution: current limit input LED, see figure 6) Maximum Reverse Voltage Limits 3.0 0.4 3.0 to 25 7.0 Units mA mA mA V OUTPUT CHARACTERISTICS Operating Voltage Range Maximum Continuous Load Current @ TA=+40C, 5mA Control (see figure 1) A Connection B Connection C Connection Maximum Pulsed Load Current @TA=+25C, (100 ms @ 10% duty cycle) A Connection Maximum On-State Resistance @TA=+25C, for 1A pulsed load, 5mA Control (see figure 4) A Connection B Connection C Connection Maximum Off-State Leakage @ TA=+25C, 16VDC Maximum Turn-On Time @TA=+25C (see figure 7), for 1A, 20 VDC load, 5mA Control Maximum Turn-Off Time @TA=+25C (see figure 7), for 1A, 20 VDC load, 5mA Control Maximum Output Capacitance @ 20VDC (see figure 2) Limits 0 to 20 2.5 3.0 4.5 6.0 100 65 40 10 5.0 0.5 300 Units V(DC or AC peak) A (DC or AC) A (DC) A (DC) A (DC or AC) m nA ms ms pF GENERAL CHARACTERISTICS Minimum Dielectric Strength, Input-Output Minimum Insulation Resistance, Input-Output, @TA=+25C, 50%RH, 100VDC Maximum Capacitance, Input-Output Maximum Pin Soldering Temperature (10 seconds maximum) Ambient Temperature Range: Operating Storage Limits 4000 1012 1.0 +260 -40 to +85 -40 to +100 Units VRMS pF C Connection Diagrams 2 www.irf.com Series PVN013 3.0 Max. Load Current (A) 1000 I LED = 5 mA I LED = 3 mA "A" Connection 2.0 1.5 1.0 0.5 0 0 20 40 60 80 100 Ambient Temperature (deg. C) Figure 1. Current Derating Curves* 2.5 1.5 2.0 1.0 0.5 0 -0.5 -1.0 -1.5 -2.0 -2.5 -0.25 -0.20 -0.15 -0.10 -0.05 0 0.05 0.10 0.15 0.20 0.25 Typical Capacitance (pF) 2.5 800 600 400 200 0 "A" Connection 20 5 10 15 Vdd, Drain to Drain Voltage (V) Figure 2. Typical Output Capacitance 2.5 "A" Connection 5 mA Control ID = 1 A 0 Rd-on (Normalized to 25 C) 2.0 1.5 1.0 Load Current (A) 0.5 0 -50 -25 0 25 50 75 100 125 Ambient Temperature (deg. C) 5 mA Control @ 25C, pulsed Connection "A" Voltage Drop (Vdd) Figure 3. Linearity Characteristics 100 30 Figure 4. Typical Normalized On-Resistance 20 16 Input Current (mA) ID-OFF/ ID-OFF 25C 10 3.0 1.0 0.3 0.1 -35 Min. device and +85 12 8 4 0 TYPICAL -15 5 25 45 65 85 105 Ambient Temperature (deg. C) 0 0.5 1.0 Max. device and 1.5 -40 deg. C limit deg. C limit CAUTION: provide current limiting so that 25mA maximum steady state control current rating is not exceeded. 2.0 LED Forward Voltage Drop (Volts DC) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) * Derating of `B' and `C' connection at +85C will be 70% of that specified at +40C and is linear from +40C to +85C. www.irf.com 3 Series PVN013 20 LED Current (mA) 10 I LED t dly t on 90% 5 toff 3 0.05 0.1 0.2 0.5 1.0 2.0 5.0 10% ID t dly t off t on Delay Time (milliseconds) Figure 7. Typical Delay Times Figure 8. Delay Time Definitions Case Outline 01-2008 01 4 www.irf.com Series PVN013 Case Outline 01-2009 IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 252-7105 Data and specifications subject to change without notice. 6/13/2001 www.irf.com 5 |
Price & Availability of 2570
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |