| PART |
Description |
Maker |
| V275PA20A V275PA40A V275PA40B V275PA40C V150PA20B |
RATINGS AND CHARACTERISTICS TABLE
|
New Jersey Semi-Conductor Products, Inc.
New Jersey Semi-Conduct...
|
| EP3C25F256I7N EP3C25Q240C8N EP3C10E144C7 EP3C10F25 |
1. Cyclone III Device Datasheet
The following sections provide information about the absolute maximum ratings, recommended operating conditions, DC characteristics, and other specifications for Cyclone IIIdevices
This chapterdescribes the electric characteristics, switching characteristics,and I/O timing for Cyclone III devices. A glossary is also included for your reference
This chapter describes the electric characteristics, switching characteristics, and I/O timing for Cyclone? III devices. A glossary is also included for your reference.
|
Altera Corporation
|
| VLF3010ST-100MR53 VLF3012ST-100MR59 VLF3012ST-150M |
L-Q Frequency Characteristics, DC Bias & Temperature Characteristics(1MHz), Temperature Rise
|
TDK Electronics
|
| RX6000 |
RFM products are now Murata products
|
Murata Manufacturing Co...
|
| TR3000 |
RFM products are now Murata products
|
Murata Manufacturing Co...
|
| LEM2520 LEM2520T470J LBM2016T4R7J LBM2016T470J LBM |
Notice for TAIYO YUDEN products
WIRE-WOUND CHIP INDUCTORS FOR SIGNAL LINES (LB SERIES M TYPE)
Please read this notice before using the TAIYO YUDEN products.
|
Taiyo Yuden (U.S.A.), Inc
Taiyo Yuden (U.S.A.), I...
|
| L0806C100MDWST L0806CR10MDWST L0806C10NMDWST L0806 |
Surface Mount Ferrite Products
Surface Mount Ferrite Products Inductors & Ferrite Beads
Wire Wound Chip Inductors - L-PWS/L-PWF/L-PWI/L-PWR Series
|
Kemet Corporation
|
| PA10M 883 |
TABLE 4 GROUP A INSPECTION
|
APEX[Apex Microtechnology]
|
| PA07M |
TABLE 4 GRUOP A INSPECTION
|
APEX[Apex Microtechnology]
|
| PA12M PA12M/883 |
Table 4 Group A Inspection
|
Cirrus Logic
|
